Peeked my interest.

Ok, you’ve peaked my interest and I would like to hear the album “Drums & Octobass” by Keiji Haino & Guro Moe

https://conradsound.bandcamp.com/album/drums-octobass

I’ll try it in my car later and on my home system with a decent sub

I really hope that “flower which is orange and very strong-willed” lives up to my very high expectations

Edit: ok, I listened to this turned up nice and loud and it’s quite amazing but not at all in the way I expected. I know what album I am gifting my family and coworkers with this Christmas.

Can we use them for transplants?

Like flying sloths! They can move quickly when they really want to as well.

I pray I never reach this level of desperation.

So much more elegant than the rashes I get when stressed.

What brand are they? These typically do burn out over time. You got some good ones.

And if you’re still confused by these units, it’s moving about as fast as the NASDAQ.

Damn that’s hot.

It’s super simple but also kind of genius. A simple twist of perspective can change the mundane into the profound.

Can I tell you about my favorite Linux distro for a min?

That’s fine, but you wake me up to tell me about it at 3am, we are not soul mates. You are dead man walking, later, after I’ve had some coffee.

Yes due to outdoors. Even in low light, UV can add up and also, it takes quite some time, but even racemic pla does start to break down with aqueous exposure.

Recommend buying a dedicated butane torch (<$40) for print cleanup. Something in between a zippo and a crem brulee torch. Works wonders on removing and stranding on your prints.

Polycrillic finish is pretty inert stuff. Can’t imagine a sealant layer of it would be too toxic to plants or get significantly incorporated into any edible plant materials. I use polycrillic coated pla for weighing out coffee beans.

Ambitious early project. I’d probably go with petg.

There are plenty of good tutorials / suggestions for general water tightness with regards to slicer settings. Water tight joints will be tricky. Consider sanding and then torching them. I’ve had good results with clearcoat spray after sanding pla. May work with petg too.

Curious why you didn’t go with xl for this? Cost?

Can you imagine if US and MX flipped? The prophecy of Mexico paying to build the wall could finally be realized.

Is that why their ears are so big?

Are you just changing the subject?

Just curious, how do you ever find the time to masturbate?

Nah man, 5min sounds like a marathon. Not everyone is wired like a porn star.

Not a very flattering picture of Ms. Stump, but ok.