I don’t notice which hand they use, but more often than not, lefties will write with their hand curved over (and smudging) the text they just wrote instead of from beneath (and not smudging.) That’s when I notice. So when I notice, I don’t say, “You know you could prevent getting graphite (or ink) everywhere…” I say, “Ah. Leftie.”
I have seen righties do the same weird smudging with the arced wrist. Why do people write like that?
I recently asked about having my coating re-applied, and the folks at the eye place had a warranty system, where if it came off inside of two years, they’d strip and re-coat the lenses. Might call them to find out if you’re covered, or of they can tell you the stripping method.
Alcohol would, too. Further, avoid mineral spirits and petroleum based solvents entirely.
Lol, Tomb of Horrors last resort wish gem.
Lol. Nah, my brother woke me up in crisis to have a conversation in text instead of over the phone, so my wife left to sleep in her own bed in a huff, and I just started new meds …
His name was Terry Davis.
Particularly with leftover adhesive, post-its…
You mean you wouldn’t expect a software engineer to understand the coefficient of thermal expansion of tungsten carbide in a gas lubricated piston/cylinder pneumatic deadweight calibration system?
Yeah, me either. But I would expect one to know how to research the documentation to find out what it meant.
You are doing it right.
[Edited because of weird auto-formatting. Edit 2 added more pedantry. Edit 3+ is because I lost the plot and had to bring it back.]
Because the SI unit for temperature is the Kelvin, which has already been stated. It has also been mentioned that K and °C are the same but with different offsets. It has not been mentioned that °C is to K as Degrees Fahrenheit (°F) is to Rankine ( R). It would be similarly inappropriate to say “millidegrees Fahrenheit” or “kilofahrenheit”. I have no idea if mR or kR would be appropriate, though.
I would offer that there are two ways to look at SI (“metric”) prefixes, and these can be thought of similarly with the multipliers they represent: as a prefix to the unit, by definition; or as a suffix to the value. Let me illustrate with an example.
38,000 K could be expressed 38 kK, or “thirty-eight kiloKelvin”. It could also be spoken “thirty-eight thousand Kelvin” (or Kelvins, idfk). This isn’t normally important for the layperson, but suppose you have a temperature meter (and, literally, I do not mean “thermometer”) that has only 4 digits of resolution. 38.00 k (“38,00 k” for the Europeans?) would be how it reads out the value in question. This would be 38 kK, certainly, due to the position of the decimal.
Now suppose that temperature meter read out in °C. 38.00 k °C would, in fact, denote “thirty-eight thousand degrees Celsius” for the reasons mentioned above.
So, because Degrees Celsius is not an SI unit, in the technical sense…
Btw, I have been explicitly using upper case letters when spelling out the units. This is incorrect. The symbols for SI (International System of Units) units should be capitalized when they respect a person (K, A). The names of the units should be all lower case because you are not naming the person, but the unit named after them (kelvin after Lord Kelvin, and ampere after Andre-Marie Ampere).
Yeah, I know. I’m being pedantic. It’s literally my job. I really should be sleeping right now. Here’s a source: https://www.bipm.org/en/measurement-units/si-base-units
This is my current conundrum. I was going to go in early anyway, but …
Fuck it, you’ve convinced me. I need to have a tête-à-tête with another tech about following procedures with intent. Probably should be there first.